Run command BEFORE as ransomware protection

[frytex]

I already saw a suggestion of running a command before syncing.

but I'd like to emphasize that this in fact would be very useful to protect the copied files.

scenario:
1. run a command to map a drive with user&pass (or a batch with these credentials)
2. make a copy
3. disconnect (log out of) the target drive

this way the copy remains inaccessible to a ransomware running on the source computer. of course there's always a chance that the files would be encrypted during syncing, but this is much less likely.

I know this can be bypassed by running FFS from a batch file that would connect the drive first, but it is already a tricky way to do it, especially while using a task scheduler. therefore a built-in feature would be very appreciated.

[xCSxXenon]

I know this can be bypassed by running FFS from a batch file that would connect the drive first, but it is already a tricky way to do it, especially while using a task scheduler. therefore a built-in feature would be very appreciated.

If you already use Task Scheduler, this shouldn't be any easier from within the FFS GUI than within a batch file.