retitling saved batch job files in a folder and clicking on them to start the process.

[tsoilihoi]

I have 9 specific jobs from different source locations to 3 removable western digital external drives.
(As I have to unlock them creating a secondary drive letter and because the data is coming from varying drives and locations, I have to do the syncing from pc to the particular drive, manually.

Now most program have you create a menu that is permanent. I believe that the menu on the left is
volatile and just shows recent runs... So I batch saved each run to a folder and re-titled the ff_gui files (so I would know which one was for which target to which destination.

I found that if I click on the ff_gui file that it brings up the program.
I moved the nine files to a folder and am prepared to connect up each external drive and click on the appropriate batch file.

This works, am I missing anything. As I mentioned other sync programs allow the creation of a permanent menu

Now I could make 9 batch files file path to the programs exe and the first parameter path to the ff_gui file.
Or one batch file when I fill in a value 1 - 9 and it runs the correct ff file... but just clicking the particular file works.

Again, I can't run it unattended as there are files coming from multiple folders on different pc drives

Thanks for any help.

paul

[xCSxXenon]

Open FFS, then in FFS select 'Open', then select your configurations you saved. This will put them in that panel permanently

[tsoilihoi]

Thanks you!!