Is there an updated converter program to convert 4.5 scripts to 4.6? I know is
a small change but I have many FFS scripts to convert and a converter would be
easier than through the interface. I know there was on back in 3.17.
Converter
- Posts: 141
- Joined: 10 Sep 2009
-
- Site Admin
- Posts: 7212
- Joined: 9 Dec 2007
In 3.17 the GUI migration step would lose data due to structural changes,
therefore a converter was needed. In 4.6 the GUI approach is safe, it adapts
two xml values: 1. set command after sync to blank, 2. convert xml node
"silent" to "showProgress"
therefore a converter was needed. In 4.6 the GUI approach is safe, it adapts
two xml values: 1. set command after sync to blank, 2. convert xml node
"silent" to "showProgress"
- Posts: 141
- Joined: 10 Sep 2009
Yes but if you have a large number of configs to convert it can be time
consuming. Some kind of batch convert would be nice. Is there a way?
consuming. Some kind of batch convert would be nice. Is there a way?
-
- Site Admin
- Posts: 7212
- Joined: 9 Dec 2007
No, the only existing conversion is via GUI. I figure the main nuisance is
batch dialog automatically closing after saving config. Maybe unding this
"optimization" solves the problem.
batch dialog automatically closing after saving config. Maybe unding this
"optimization" solves the problem.
